|
| Mk1
INTERCOM |
| l |
This
intercom has been designed to be as universal as possible.
|
| l |
It
can be made to interface with all ICOM radios and other makes but may
require different patch leads and adjustments to the circuitry depending
on the type.
|
| l |
This
black box variant intercom is not waterproof. Although it has been shown
to work when wet on the outside due to rain showers this is not
recommended and it should be kept dry.
|
| l |
P1
socket is identified by a red circular label 1cm diameter. P2 socket is
next to P1 socket and is unmarked.
|
| l |
At
the opposite end of the box are two DIN sockets.
|
| l |
The
one opposite the P1 socket is for the patch lead to the radio.
The other is for the PTT lead.
They have different pin patterns and cannot accept the wrong plugs.
|
|
|
| Mk2
INTERCOM
|
| l |
This
slide-on variant intercom is designed inside a modified ICOM battery box
and fits in place of the original Ni-Cad battery.
|
| l |
It
has been designed to be used with ICOM IC-A22 and ICOM IC-A3.
|
| l |
It
is available in a case suitable for ICOM IC-A20 and ICOM IC-A2
|
| l |
The
patch lead is short and hard-wired into the intercom.
|
| l |
When
in position (connected to the radio) the top end of the patch lead
should be secured to the small loop on the side of the radio with the
small tie-wrap provided. Trim off excess tie-wrap.
|
| l |
This
slide-on variant intercom is not waterproof. Although it has been shown
to work when extremely wet on the outside due to heavy rain showers this
is not recommended and it should be kept dry. (Your ICOM radio is less
waterproof)
|
| l |
P1
socket is identified by a red circular label 1cm diameter. P2 socket is
next to P1 socket and is unmarked.
(Bottom entry variant) The front entry variant has a P1 selector switch
above the sockets.
|
| l |
The
intercom has its own power supply socket that accepts a DC power jack.
(Bottom right viewed from the front)
The front entry variant has the DC power socket on the left (viewed from
the front)
|
| l |
When
in position, the radio is automatically supplied with power from this
socket via the connections on the bottom of the radio.
|
| l |
Do
not use a separate supply to the radio when the intercom is in position.
It is un-necessary and could cause earth loop problems.
|
| l |
An
on-board PTT switch is supplied as standard. (Momentary toggle switch)
|
| l |
Below
this switch is a phono socket for a plug-in remote PTT. Either PTT can
be used at any time.
|
|
|
| POWER
SUPPLY
|
| l |
Both
Mk1 & Mk2 intercoms require a DC supply of 12v to 15v.
|
| l |
13v6
is ideal as provided by most good rectifier/regulators. FLYCOM intercoms
have been run from a Key West regulator without a battery although a
battery with a 3 amp fuse is recommended.
|
| l |
Distortion
of the audio will occur when the voltage drops below 11v.
|
| l |
The
intercoms will stand an absolute maximum of 22v but your ICOM radio will
fail above 15v.
|
| l |
The
intercoms are polarity protected. Your radio probably isn’t. Make sure
the battery is connected the right way round.
|
| l |
The
power jack should have centre +ve, sleeve –ve.
|
|
|
|
|
|
IMPORTANT |
|
|
| FLYCOM
Mk1 & Mk 2 INTERCOMS have fixed volume outputs. They have been
designed to work with the FLYCOM flying helmet and the FLYCOM headset
which have their own individual volume controls allowing the volume to
be turned all the way to zero |
|
| Some
headsets and helmets of other manufacture do not have this facility |
|
The
use of the FLYCOM intercoms with FLYCOM headsets or FLYCOM flying
helmets
or of headsets or flying helmets of other manufacture is beyond the
control of FLYCOM |
|
| Users
should satisfy themselves that their equipment can control the volume
safely. |
|
| Using
a headset without a volume control with a FLYCOM intercom could be
hazardous to your health. Excessive noise has been shown to cause
permanent hearing loss |
|
| Users
should be aware that flying in powered aircraft constitutes a noisy
environment
|
|
Excessive
noise has been shown to cause fatigue and loss of concentration
|
|
|
Fatigue
and loss of concentration have been shown to cause serious injuries and
death |
|
|
|
|
|
[ Home ] [
Up ] [ Helmet User Information ] [
Headset User Information ] [ Intercom User Information ] |